اینستاگرام تی پی بین
همایش ، رویداد ، ژورنال
حوزه های تحت پوشش رویداد
  • fretting corrosion of cocrmo and ti6al4v interfaces

    جزئیات بیشتر مقاله
    • تاریخ ارائه: 1391/01/01
    • تاریخ انتشار در تی پی بین: 1391/01/01
    • تعداد بازدید: 638
    • تعداد پرسش و پاسخ ها: 0
    • شماره تماس دبیرخانه رویداد: -
     mechanically assisted corrosion (fretting corrosion, tribocorrosion etc.,) of metallic biomaterials is a primary concern for numerous implant applications, particularly in the performance of highly-loaded medical devices. while the basic underlying concepts of fretting corrosion or tribocorrosion and fretting crevice corrosion are well known, there remains a need to develop an integrated systematic method for the analysis of fretting corrosion involving metal-on-metal contacts. such a method can provide detailed and quantitative information on the processes present and explore variations in surfaces, alloys, voltages, loadings, motion and solution conditions. this study reports on development of a fretting corrosion test system and presents elements of an in-depth theoretical fretting corrosion model that incorporates both the mechanical and the electrochemical aspects of fretting corrosion. to demonstrate the capabilities of the new system and validate the proposed model, experiments were performed to understand the effect of applied normal load on fretting corrosion performance of ti6al4v/ti6al4v, cocrmo/ti6al4v, and cocrmo/cocrmo material couples under potentiostatic conditions with a fixed starting surface roughness. the results of this study show that fretting corrosion is affected by material couples, normal load and the motion conditions at the interface. in particular, fretting currents and coefficient of friction (cof) vary with load and are higher for ti6al4v/ti6al4v couple reaching 3 ma/cm2 and 0.63 at about 73 mpa nominal contact stress, respectively. ti6al4v coupled with cocrmo displayed lower currents (0.6 ma/cm2) and cof (0.3), and the fretting corrosion behavior was comparable to cocrmo/cocrmo couple (1.2 ma/cm2 and 0.3, respectively). information on the mechanical energy dissipated at the interface, the sticking behavior, and the load dependence of the inter-asperity distance calculated using the model elucidated the influence of mechanical factors on the experimental results. it was observed that the lowest amount of work was required to generate some of the highest fretting corrosion currents in ti6al4v/ti6al4v couples compared to the other combinations. the elements of the model presented here provide an excellent basis to explain many of the observed behaviors of these interfaces.

سوال خود را در مورد این مقاله مطرح نمایید :

با انتخاب دکمه ثبت پرسش، موافقت خود را با قوانین انتشار محتوا در وبسایت تی پی بین اعلام می کنم
مقالات جدیدترین رویدادها
مقالات جدیدترین ژورنال ها