-
influence of processing parameters and particle size on the properties of hot work and high speed tool steels by spark plasma sintering
جزئیات بیشتر مقاله- تاریخ ارائه: 1390/01/01
- تاریخ انتشار در تی پی بین: 1390/01/01
- تعداد بازدید: 434
- تعداد پرسش و پاسخ ها: 0
- شماره تماس دبیرخانه رویداد: -
spark plasma sintering (sps) is a newly developed rapid technique for powder sintering. in this study, consolidation by sps of high speed steel (aisi m2) and hot work tool steel (aisi h13) commercial powders is investigated. the influence of sintering temperature (900 to 1150 °c) and time (0 to 30 min) as well as the particle size and distribution is evaluated with respect to final density, hardness and fracture toughness. properties have been compared with those of samples produced by hot isostatic pressing (hip). density increases with increasing temperature up to 1050 and 1100 °c for h13 and m2, respectively, a minor influence of time being observed for times longer than 5 min. near fully dense samples (>99.5%) are obtained after sintering at 1100 °c for 5 min only under uniaxial pressure of 60 mpa. fine powders with a narrow size distribution or, alternatively, powders with a wider particle distribution and sufficiently high fraction of small particles show higher propension towards the achievement of full dense samples. the maximum densification rate occurs at lower temperature for h13 than m2, being negatively affected by the ferrite–austenite transformation during heating and the corresponding resistivity variation. hardness and fracture toughness are found to increase with increasing density. comparatively good values are obtained with respect to samples produced by hot isostatic pressing confirming the possibility to produce tools by sps.
مقالات جدیدترین رویدادها
-
استفاده از تحلیل اهمیت-عملکرد در ارائه الگوی مدیریت خلاقیت سازمانی و ارائه راهکار جهت بهبود
-
بررسی تاثیر ارزش وجوه نقد مازاد بر ساختار سرمایه شرکت های پذیرفته شده در بورس اوراق بهادار تهران
-
بررسی تأثیر سطح افشای ریسک بر قرارداد بدهی شرکت های پذیرفته شده در بورس اوراق بهادار تهران
-
بررسی تأثیر رتبه بندی اعتباری مبتنی بر مدل امتیاز بازار نوظهور بر نقد شوندگی سهام با تأکید بر خصوصی سازی شرکت ها
-
تأثیر آمیخته بازاریابی پوشاک ایرانی بر تصویر ذهنی مشتری پوشاک ایرانی (هاکوپیان)
-
بررسی پتروگرافی و پتروفابریک میکاشیست های کمپلکس ژان واقع در نوار سنندج – سیرجان
-
سنجش پایداری اجتماعی در محلات شهری (مطالعه موردی: محله های مرداویچ و مفت آباد شهر اصفهان)
-
membrane gas separations and post-combustion carbon dioxide capture: parametric sensitivity and process integration strategies
-
effect of joint opening on p-wave velocity measurement in andesite rock samples
-
studies on stability and coking resistance of ni/batio3–al2o3 catalysts for lower temperature dry reforming of methane (ltdrm)
مقالات جدیدترین ژورنال ها
-
مدیریت و بررسی افسردگی دانش آموزان دختر مقطع متوسطه دوم در دروان کرونا در شهرستان دزفول
-
مدیریت و بررسی خرد سیاسی در اندیشه ی فردوسی در ادب ایران
-
واکاوی و مدیریت توصیفی قلمدان(جاکلیدی)ضریح در موزه آستان قدس رضوی
-
بررسی تاثیر خلاقیت، دانش و انگیزه کارکنان بر پیشنهادات نوآورانه کارکنان ( مورد مطالعه: هتل های 3 و 4 ستاره استان کرمان)
-
بررسی تاثیر کیفیت سیستم های اطلاعاتی بر تصمیم گیری موفق در شرکتهای تولیدی استان اصفهان (مورد مطالعه: مدیران شرکتهای تولیدی استان اصفهان)
-
سنجش کیفیت و ظرفیت گردشگری با تأکید بر الگوهای رفتاری گردشگران در مشهد
-
رفتارشناسی پیامبر اکرم (ص) در تعاملات اجتماعی با یهودیان مدینه
-
مطالعه تطبیقی نظریه تقلید در باب هنر از دیدگاه فلسفه غرب و فلاسفه ایرانی اسلامی
-
experimental assessment of porous material anisotropy and its effect on gas permeability
-
incorporating of two waste materials for the use in fine-grained soil stabilization
سوال خود را در مورد این مقاله مطرح نمایید :