محبوبترین نویسندگان :
نویسندگان مقالات پربازدید :
مواد و طراحی
جزئیات رویداد
اینستاگرام تی پی بین
همایش ، رویداد ، ژورنال
حوزه های تحت پوشش رویداد

  • post-welding formability of az31 magnesium alloy

    نویسندگان :
    کلمات کلیدی :
    جزئیات بیشتر مقاله
    • تاریخ ارائه: 1390/01/01
    • تاریخ انتشار در تی پی بین: 1390/01/01
    • تعداد بازدید: 435
    • تعداد پرسش و پاسخ ها: 0
    • شماره تماس دبیرخانه رویداد: -
     the plastic flow behaviour and formability of friction stir welded az31 magnesium alloys were widely investigated. flow curves were obtained in extended ranges of temperature (250–350 °c) and strain rate (0.001–0.1 s−1) by means of uniaxial tensile tests; furthermore, forming limit curves were determined using the hemispherical punch method in the same range of temperature but with a constant crosshead speed of 0.1 mm/s. the results were compared with those obtained, under the same experimental conditions, on the base material. the flow stress levels of joint and base material are very similar up the peak of the flow curve although the equivalent strains at the peak and to failure are usually lower than those of base material. however, at the highest temperature and lowest strain rate investigated (350 °c and 0.001 s−1), the flow behaviour of the welded joint tends to be similar to the one of the base alloy. finally, formability of the friction stir welded material, evaluated in terms of forming limit curves, is usually lower than the one of the base material.

سوال خود را در مورد این مقاله مطرح نمایید :

با انتخاب دکمه ثبت پرسش، موافقت خود را با قوانین انتشار محتوا در وبسایت تی پی بین اعلام می کنم
مقالات جدیدترین رویدادها
مقالات جدیدترین ژورنال ها